Automatic Hygienic Toilet Seat Plastic Film System with Touchless Sensor
The NAVISANI toilet seat is automatically controlled by a build-in microcomputer inside, the sanitary wrap will stop after turning exactly one round. The used film roll is destroyed by a cutter to ensure one time use.
Just by pressing the stainless steel button or putting your hand before sensor device before your usage, the roller will activate automatically to replace the used seat film with fresh one to ensure a new toilet seat for your every usage, which is much easy & convenient.
Toilet Seat - ABS(Plastic)
Film Covering - HDPE(Plastic, food grade)
Activated by Stainless Steel Button, stand destroying, exceed 200,000 use times;
Activated by Infrared Sensor (Touch Free, 6-12cm)
Microcomputer & Indication Light (Red):
Overload warning signal: LED light will stay on for 2 seconds;
If no loading / counter wheel fault / the film roller is not installed in place signal: LED light is on all the time;
The LED will flash when battery is in low voltage;
Restarting interval (6 seconds) to avoid waste
Rechargeable battery: One battery charging can be used more than 3,000 times.
Adapter: input voltage 100V-240V, output voltage: DC 6-7.5V.
If the power supply is available around the toilet:
Open the white tarpaulin located on the back of pedestal and have it charged.
If the power supply is not available around the toilet:
A. push the lever on the bottom, then take out the seat and have it charged where power supply is available. B. open the cover located on the back of pedestal, pull the red ribbon and take out the battery, then have it recharged where available.
Soft Closing Cover:
NAVISANI toilet cover have a damper, which can make it close softly, exceed 50,000 use times.
A red line will appear when the seat film remains 1-2m, it reminds you to replace the film roll .
Horizontal distance: 130-200mm (Distance between two installation holes)
Vertical distance: 450-490mm (From center between two installation holes to the top front of toilet bowl)